Amateur DIY woodworking in India

... well - by dropping the hydraulic and revolving features ! I had a couple of chairs in my study room with hydraulic lifts (not that I needed this feature - the chairs were always set at their highest) and 5 revolving casters at the base. Both of them had their hydraulic struts at the end of their life, which means they frequently sank without notice ! Couple of weeks back in a lazy afternoon weekend, I got a little too comfortable on one of them when one of the legs gave away, and I crashed to the floor, face up, and in the process hurt my right shoulder (enough to keep me out of tennis for couple of weeks). The broken base : The chair was now unusable and dangerous , so I planned on decommissioning it and getting a new one (now I DID NOT need a new one with hydraulic lift and revolving features). But at second thoughts, other than the broken leg, and the unusable gas strut, everything else was fine with the chair. So I took it up ...

... a convenience caddy for the bedroom The itch started when I noticed the awkwardly placed and unwieldy plastic table that holds the condiments in a corner of our dining room. It was eating up a lot of space which was not fully utilized, and the lower rack is exclusively used by the cats as a bunk bed. Planned to build something with a smaller footprint and on casters, so that the usability and mobility factor increases. Once I got my Metabo table saw, I dismantled the home built saw/router table and reclaimed some 19mm plywood and Sal wood battens from it. Also I had some 12mm plywood scrap pieces from previous projects . And I have some laminates lying around too. I determined the above would be enough to complete this project. Got the 12mm  19mm plywood and the Sal battens sized up, planed and squared. Cut the corners of the bottom and middle racks to accommodate the posts. Put pocket holes, 2 in each corner. And then glued and screwed the posts...

Few small projects using scraps Just thought of putting up all my small projects till date on a single page.  These projects made effective use of scraps lying around in my shop.  Almost all of them do not have detailed step by step photos - just the end results. 1. Coaster Had some 12 mm ply, beading and broken laminates. An hour later this coaster came out. Beading stained with walnut color stain from Asian Paints. 2. Medicine Box Started as a bare-bones plywood box using 12 and 19 mm ply, then found some unused odd sized laminates left on the floor, so used them too.  Then my wife suggested that we use this as a Homeopathy medicine box. So found some 6 mm ply and used a spade bit on my drill press to put 16mm holes in the same. Finally propped the 6 mm piece on 2 sides by using 2 smaller 6 mm pieces. 3. Storage space door We have quite a few open storage spaces in our dining room. One of them has som...

Clothing organization 101 - Bedroom Dresser During my twenties, I was an impulsive shopper for clothes, and by that process, have gathered a huge cache of t shirts/polos/trousers/jeans etc which took up most if not all the space in my closet. It was hard for me to organize my hosiery, socks and other sundry items in the same closet. Now the closet that I use is a old wooden one that was passed down to me by my father, who in turn got his from his parents. It is made of solid Burma teak and is irreplaceable at this moment. So I decided to build a dresser inspired from one of Mathias Wandel's numerous dresser designs (with significant deviations and mistakes along the way), which shall be placed beside my wife's larger closet in our bedroom. Used sal (shorea robusta) wood and ply (6 mm for sides, 12 mm for drawers, 12 mm for top). Started off by building the drawer boxes first (which was the first of my many mistakes, as I should have built the drawers after I built...